Products

①.Man-machine interface HMl setting KT stem parameters such as glass width length underknife pressure. etc--mechanical placement of alass into the KTnchronous belt area of the cutting table;
②Automatic transmission and positioning of glass according to the cut size of input (There's a location KTstem)
③Knife head at zero -Pneumatic lower knife, upper and lower knife wheel cut (There's an automatic injection KTstem)-Cut and lift-The up perpress starts the press, and the lower surface glass breaks open--Under the top rod up the glass, the upper surface of the glass break open--Heat bar start heating -The vacuum suction cup absorbs the glass on both sides of the tangent line and pulls the cutting seam apart
④Cutting film (PVB or EVA)--The cutting action is complete and the entire artifact istransferred to the next segment tangent position(lf you need to turn around and cut you need to do it manually)
⑤Manually move the processed glass to thelower slide flip bracket with the air float assembly.

Send Inquiry - Automatic Laminated Glass Cutting Machine

*Your email address will not be published. Required fields are marked.